KTAG 7.020 User Guide On BMW E & F series EDC17CP45 ECU Reading/Writting

K-Tag Ktag 7.020 2.23 is the newest KTAG Master Tool that just introducted in the marketplace in 2017. New Updated KTAG FW7.020 supports Online Full Protocols,No Token Limited.And today,this article will give a step by steps guide on how to used K-TAG 7.020 Master to read and write BMW E & F series EDC17CP45,hope it will be useful.

See KTAG 7.020 Master Preview

Things you need to prepared

1. great working KTAG 7.020 Master Kit like pix show

2.LED BDM Frame With 4 Probes Mesh For Kess Dimsport K-TAG ( not necessory,but have one,will be better and will be useful),see pix show

Things you need to know before starting

The operation between BMW E & F series EDC17CP45 read/write is different : When you would like to read/write EDC17CP45 from E-series you only need to drill a hole in back of ECU to get into bootpin. But for F-series, No need open the ECU and drill one hole for bootpin or more to get into GPT.

Step by Steps Guide

1.You need to disassemble ECU from the car. ( Pls careful,it is not hard to open the ECU).

2.then connect your KTAG with PC ( You dont need disconnect with internet when you use.)

3. Then install latest Ksuite 2.32 sotware to install and setup latest software

4. After finished,then you can to read and write your BMW E & F series EDC17CP45
ECU

                               
5.you need some solder skills



The Steps looks difficult,yet,it is easy to do by yourselves,pls dont worry.